Search results
Results From The WOW.Com Content Network
Damper winding. Bars and rings of the damper (amortisseur) winding of an AC generator (General Electric, early 20th century). Note the gaps in the cage along the quadrature axes. The damper winding (also amortisseur winding[ 1]) is a squirrel-cage -like winding on the rotor of a typical synchronous electric machine.
These were the combination of two disk diameters: 3 + 1 ⁄ 4 inches (83 mm) and 4 + 1 ⁄ 2 inches (110 mm) and as either single or multiplate designs. Single dampers had two friction surfaces: a single arm on one side was nested between two arms connected to the other. Multiplate dampers had two and three arms on each side.
Damper (flow) Opposed blade dampers in a mixing duct. A damper is a valve or plate that stops or regulates the flow of air inside a duct, chimney, VAV box, air handler, or other air-handling equipment. A damper may be used to cut off central air conditioning (heating or cooling) to an unused room, or to regulate it for room-by-room temperature ...
Harmonic balancer lower pulley on a four-cylinder engine. A harmonic damper is a device fitted to the free (accessory drive) end of the crankshaft of an internal combustion engine to counter torsional and resonance vibrations from the crankshaft. This device must be an interference fit to the crankshaft in order to operate in an effective manner.
Overhead lines or overhead wires are used to transmit electrical energy to trams, trolleybuses or trains. Overhead line is designed on the principle of one or more overhead wires situated over rail tracks. Feeder stations at regular intervals along the overhead line supply power from the high-voltage grid.
A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes, as can one government, because each division, department, and site (campus) can have its own CAGE code.
Dortch Stove Works. / 35.93278°N 86.79333°W / 35.93278; -86.79333. Dortch Stove Works is an historic stove manufacturing plant in Franklin, Tennessee. It was built in 1929 by Allen Manufacturing Company, then based in Nashville, Tennessee. During its manufacturing prime, the plant produced stoves and ranges under Allen Manufacturing ...
July 31, 2024 at 6:00 AM. Hard-line conservatives in the House left Washington frustrated that Speaker Mike Johnson (R-La.) didn’t uphold his promises on pushing through spending legislation ...