Search results
Results From The WOW.Com Content Network
The "dilution factor" is an expression which describes the ratio of the aliquot volume to the final volume. Dilution factor is a notation often used in commercial assays. For example, in solution with a 1/5 dilution factor (which may be abbreviated as x5 dilution ), entails combining 1 unit volume of solute (the material to be diluted) with ...
Viscosity models for mixtures. The shear viscosity (or viscosity, in short) of a fluid is a material property that describes the friction between internal neighboring fluid surfaces (or sheets) flowing with different fluid velocities. This friction is the effect of (linear) momentum exchange caused by molecules with sufficient energy to move ...
In a piston engine, the static compression ratio ( ) is the ratio between the volume of the cylinder and combustion chamber when the piston is at the bottom of its stroke, and the volume of the combustion chamber when the piston is at the top of its stroke. [ 9] It is therefore calculated by the formula [ 10] where. is the displacement volume.
Lower flammability limit. The lower flammability limit ( LFL ), [ 1] usually expressed in volume per cent, is the lower end of the concentration range over which a flammable mixture of gas or vapour in air can be ignited at a given temperature and pressure. The flammability range is delineated by the upper and lower flammability limits.
SAE J300 is a standard that defines the viscometric properties of mono- and multigrade engine oils, maintained by SAE International. [ 1] Key parameters for engine oil viscometrics are the oil's kinematic viscosity, its high temperature-high shear viscosity measured by the tapered bearing simulator, and low temperature properties measured by ...
The gas/oil ratio (GOR) is the ratio of the volume of gas ("scf") that comes out of solution to the volume of oil — at standard conditions. In reservoir simulation gas/oil ratio is usually abbreviated . A point to check is whether the volume of oil is measured before or after the gas comes out of solution, since the remaining oil volume will ...
Mass concentration, g/ (100 ml) at 15.56 °C. Density relative to 4 °C water. Density at 20 °C relative to 20 °C water. Density at 25 °C relative to 25 °C water. Freezing temperature, °C. 10 °C. 20 °C. 25 °C.
Mole ratio. In atmospheric chemistry, mixing ratio usually refers to the mole ratio ri, which is defined as the amount of a constituent ni divided by the total amount of all other constituents in a mixture: The mole ratio is also called amount ratio. [ 2] If ni is much smaller than ntot (which is the case for atmospheric trace constituents ...