Search results
Results From The WOW.Com Content Network
Wi-Fi Protected Access ( WPA ), Wi-Fi Protected Access 2 ( WPA2 ), and Wi-Fi Protected Access 3 ( WPA3) are the three security certification programs developed after 2000 by the Wi-Fi Alliance to secure wireless computer networks. The Alliance defined these in response to serious weaknesses researchers had found in the previous system, Wired ...
The recommended solution to WEP security problems is to switch to WPA2. WPA was an intermediate solution for hardware that could not support WPA2. Both WPA and WPA2 are much more secure than WEP. To add support for WPA or WPA2, some old Wi-Fi access points might need to be replaced or have their firmware upgraded.
IEEE 802.11i-2004, or 802.11i for short, is an amendment to the original IEEE 802.11, implemented as Wi-Fi Protected Access II (WPA2). The draft standard was ratified on 24 June 2004. This standard specifies security mechanisms for wireless networks, replacing the short Authentication and privacy clause of the original standard with a detailed ...
The primary enhancement over WPA is the inclusion of the AES-CCMP algorithm as a mandatory feature. Both WPA and WPA2 support EAP authentication methods using RADIUS servers and preshared key (PSK). The number of WPA and WPA2 networks are increasing, while the number of WEP networks are decreasing, because of the security vulnerabilities in WEP.
In computer networking, a wireless access point, or more generally just access point ( AP ), is a networking hardware device that allows other Wi-Fi devices to connect to a wired network or wireless network. As a standalone device, the AP may have a wired or wireless connection to a router or router, but, in a wireless router, it can also be an ...
IEEE 802.11 is also a basis for vehicle-based communication networks with IEEE 802.11p . The standards are created and maintained by the Institute of Electrical and Electronics Engineers (IEEE) LAN/ MAN Standards Committee (IEEE 802). The base version of the standard was released in 1997 and has had subsequent amendments.
The WPS push button (center, blue) on a wireless router showing the symbol defined by the Wi-Fi Alliance for this function. Wi-Fi Protected Setup ( WPS) originally, Wi-Fi Simple Config, is a network security standard to create a secure wireless home network . Created by Cisco and introduced in 2006, the purpose of the protocol is to allow home ...
All base stations in a wireless distribution system must be configured to use the same radio channel, method of encryption (none, WEP, WPA or WPA2) and the same encryption keys. They may be configured to different service set identifiers (SSIDs). WDS also requires every base station to be configured to forward to others in the system.