Ads
related to: usb 2.0 high speed hubtemu.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
To allow high-speed (USB 2.0) devices to operate in their fastest mode, all hubs between the devices and the computer must be high-speed. High-speed devices should fall back to full-speed (USB 1.1) when plugged into a full-speed hub (or connected to an older full-speed computer port). While high-speed hubs can communicate at all device speeds ...
It is intended primarily to save cost in low-bandwidth human interface devices (HID) such as keyboards, mice, and joysticks. Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0.
The throughput of each USB port is determined by the slower speed of either the USB port or the USB device connected to the port. High-speed USB 2.0 hubs contain devices called transaction translators that convert between high-speed USB 2.0 buses and full and low speed buses. There may be one translator per hub or per port.
Optionally, the hub controller may draw power for its operation as a low-power device, but all high-power ports must draw from the hub's self-power. Where devices (for example, high-speed disk drives) require more power than a high-power device can draw, [48] they function erratically, if at all, from bus power of a single port. USB provides ...
High-Speed Inter-Chip (HSIC) is a chip-to-chip variant of USB 2.0 that eliminates the conventional analog transceivers found in normal USB. It was adopted as a standard by the USB-IF in 2007. The HSIC physical layer uses about 50% less power and 75% less board area compared to traditional USB 2.0. HSIC uses two signals at 1.2 V and has a ...
USB On-The-Go (USB OTG or just OTG) is a specification first used in late 2001 that allows USB devices, such as tablets or smartphones, to also act as a host, allowing other USB devices, such as USB flash drives, digital cameras, mouse or keyboards, to be attached to them. Use of USB OTG allows devices to switch back and forth between the roles ...
Ads
related to: usb 2.0 high speed hubtemu.com has been visited by 1M+ users in the past month