Search results
Results From The WOW.Com Content Network
Pharmacists have since moved to metric measurements, with a drop being rounded to exactly 0.05 mL (50 μL, that is, 20 drops per milliliter). In hospitals, intravenous tubing is used to deliver medication in drops of various sizes ranging from 10 drops/mL to 60 drops/mL.
For a given drip chamber (when the fluid drips from the hole into the chamber) drop factor means number of drops per ml of the IV fluid. Flow rate can be calculated with the help of the observations from the drip chamber and its drop factor. The unit of flow rate is gtts/min, where gtts means guttae (Latin plural noun meaning “drops”).
The energy factor metric only applies to residential water heaters, which are currently defined by fuel, type, and input capacity. [5] Generally, the EF number represents the thermal efficiency of the water heater as a percentage, since it is an average of the ratio of the theoretical heat required to raise the temperature of water drawn to the amount of energy actually consumed by the water ...
Energy conversion efficiency ( η) is the ratio between the useful output of an energy conversion machine and the input, in energy terms. The input, as well as the useful output may be chemical, electric power, mechanical work, light (radiation), or heat. The resulting value, η (eta), ranges between 0 and 1. [ 1][ 2][ 3]
Condensing boiler. Condensing boilers are water heaters typically used for heating systems that are fueled by gas or oil. When operated in the correct circumstances, a heating system can achieve high efficiency (greater than 90% on the higher heating value) by condensing water vapour found in the exhaust gases in a heat exchanger to preheat the ...
Pure water has a charge carrier density similar to semiconductors [8] [page needed] since it has a low autoionization, K w = 1.0×10 −14 at room temperature and thus pure water conducts current poorly, 0.055 μS/cm. [9] Unless a large potential is applied to increase the autoionization of water, electrolysis of pure water proceeds slowly ...
Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted convection and heated water to flow out of the tank. [ 1][ 2] Newer water heaters have built-in heat traps.
An electric resistance heater has a thermal efficiency close to 100%. [8] When comparing heating units, such as a highly efficient electric resistance heater to an 80% efficient natural gas-fuelled furnace, an economic analysis is needed to determine the most cost-effective choice.