Search results
Results From The WOW.Com Content Network
Since 1982, STP has been defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of exactly 10 5 Pa (100 kPa, 1 bar ). NIST uses a temperature of 20 °C (293.15 K, 68 °F) and an absolute pressure of 1 atm (14.696 psi, 101.325 kPa). [ 3] This standard is also called normal temperature and pressure (abbreviated as NTP ).
International Standard Atmosphere. The International Standard Atmosphere ( ISA) is a static atmospheric model of how the pressure, temperature, density, and viscosity of the Earth's atmosphere change over a wide range of altitudes or elevations. It has been established to provide a common reference for temperature and pressure and consists of ...
The density of a gas at a specific pressure can be estimated by using the ideal gas law. Doubling absolute pressure doubles the density of a gas, and doubling absolute temperature halves the density. The number of molecules in a given gas volume depends on the pressure and temperature. This is why the pressure and temperature must be stated in ...
Boyle's law is a gas law, stating that the pressure and volume of a gas have an inverse relationship. If volume increases, then pressure decreases and vice versa, when the temperature is held constant. Therefore, when the volume is halved, the pressure is doubled; and if the volume is doubled, the pressure is halved.
The laws describing the behaviour of gases under fixed pressure, volume, amount of gas, and absolute temperature conditions are called Gas Laws.The basic gas laws were discovered by the end of the 18th century when scientists found out that relationships between pressure, volume and temperature of a sample of gas could be obtained which would hold to approximation for all gases.
The gas constant occurs in the ideal gas law: = = where P is the absolute pressure, V is the volume of gas, n is the amount of substance, m is the mass, and T is the thermodynamic temperature. R specific is the mass-specific gas constant. The gas constant is expressed in the same unit as molar heat.
The pressure on a pressure-temperature diagram (such as the water phase diagram shown above) is the partial pressure of the substance in question. A phase diagram in physical chemistry , engineering , mineralogy , and materials science is a type of chart used to show conditions (pressure, temperature, etc.) at which thermodynamically distinct ...
The standard atmosphere was originally defined as the pressure exerted by a 760 mm column of mercury at 0 °C (32 °F) and standard gravity (g n = 9.806 65 m/s 2). [2] It was used as a reference condition for physical and chemical properties, and was implicit in the definition of the Celsius temperature scale, which defined 100 °C (212 °F) as the boiling point of water at this pressure.