Search results
Results From The WOW.Com Content Network
A boundary microphone (or pressure zone microphone) is one or more small omnidirectional or cardioid condenser mic capsule (s) positioned near or flush with a boundary (surface) such as a floor, table, or wall. The capsule (s) are typically mounted in a flat plate or housing. The arrangement provides a directional half-space pickup pattern ...
3D sound localization. 3D sound localization refers to an acoustic technology that is used to locate the source of a sound in a three-dimensional space. The source location is usually determined by the direction of the incoming sound waves (horizontal and vertical angles) and the distance between the source and sensors.
The improvement compared with omnidirectional reception/transmission is known as the directivity of the array. Beamforming can be used for radio or sound waves. It has found numerous applications in radar, sonar, seismology, wireless communications, radio astronomy, acoustics and biomedicine.
Microphone. Shure Brothers microphone, model 55S, multi-impedance "Small Unidyne" dynamic from 1951. A microphone, colloquially called a mic ( / maɪk / ), [1] or mike, [a] is a transducer that converts sound into an electrical signal.
hide. A near-field magnetic induction (NFMI) communication system is a short range wireless physical layer that communicates by coupling a tight, low-power, non-propagating magnetic field between devices. The concept is for a transmitter coil in one device to modulate a magnetic field which is measured by means of a receiver coil in another device.
A ribbon microphone, also known as a ribbon velocity microphone, is a type of microphone that uses a thin aluminum, duraluminum or nanofilm of electrically conductive ribbon placed between the poles of a magnet to produce a voltage by electromagnetic induction. Ribbon microphones are typically bidirectional, meaning that they pick up sounds ...
XLR connectors (mid-50s to today) Most commonly used on professional microphones, the common 3-pin XLR connector is a standard for transferring balanced audio among professional audio equipment. The 4-pin XLR is the standard connector for intercom headsets, such as systems made by Clear-Com and Telex. Two pins are used for the mono headphone ...
For MOEMS, see microoptoelectromechanical systems. Fig. 1: (a) A capacitive fixed-fixed beam RF MEMS switch, connected in shunt to a CPW line. (b) An ohmic cantilever RF MEMS switch, connected in series to a microstrip line. A radio-frequency microelectromechanical system ( RF MEMS) is a microelectromechanical system with electronic components ...