Net Deals Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Split Bus - View topic - Reduction Gear Box - TheSamba.com

    www.thesamba.com/vw/forum/viewtopic.php?t=606033

    Notice the pictures showing the shaft shows the hole at the end of the shaft is threaded (eg. wrinkles). Use that hole to thread a bolt with a nut, washer and large socket. Press in the 6306 by turning the nut down on the washer and socket. polish the AXLE to deburr it prior to pressing in the bearing.

  3. Speedi-Sleeves for Automatic Drive Flanges - TheSamba.com

    www.thesamba.com/vw/forum/viewtopic.php?t=729717

    Location: Abiquiu, NM, USA. Posted: Sun Dec 29, 2019 1:58 pm Post subject: Re: Speedi-Sleeves for Automatic Drive Flanges. I almost said "same", but looked up the side seals and manual and auto have different p/n's. You'll need someone to mike a flange hub, or call VanCafe and have someone read the dimensions embossed on the seals for you.

  4. Parts from GoWesty vs VanCafe vs BusLab vs BusDepot vs Vanagain

    www.thesamba.com/vw/forum/viewtopic.php?t=794670&start=80

    Assuming that parts are parts is an enormous mistake. It is no different than saying that a wife is a wife. Understanding parts is a giant subject. Usually the original supplier to the vehicle manufacturer is best. But not always. Lots of parts and other commodities are available from lower bidders. Some are outright counterfeits.

  5. TheSamba.com :: Split Bus - View topic - Heater tube

    www.thesamba.com/vw/forum/viewtopic.php?t=609514

    I ended up getting a stick from my local O'reilly's auto parts. The standard US outer diameter is 2.75 ...

  6. TheSamba.com :: Buyer and Seller Feedback - View topic - Rock...

    www.thesamba.com/vw/forum/viewtopic.php?t=722204

    I have purchased parts for my 1970 VW and my trucks from Rock Auto. The parts for my 1970 VW were mostly brake parts, like the flexible lines, agner brake shoes, and the to rear drums I purchased from them under the Raybestos brand were stamped "made in Germany" and were fine. _________________. 1970 VW (owned since 1972) and 1971 VW ...

  7. Solex 31 PICT-4 repair kit - TheSamba.com :: Beetle

    www.thesamba.com/vw/forum/viewtopic.php?t=470768

    This is a 34PICT-3 shown here, but the 31PICT-3 is similar for the pilot, main and air correction jet locations. And the modification state number, most likely on the base flange across from the throttle cable attachment. I don't have an example of the number on a 31PICT-4 but it should resemble some of these: -Andy.

  8. Brosal Fuel Pump Failure Rate, How many People Effected?

    www.thesamba.com/vw/forum/viewtopic.php?t=611747

    the search is down but there is a good post in the bus forums about using one of these new but oldschool pumps from a regular auto parts store. It covers both the pin issue, and the fact that it pumps way too high of PSI. The suggestion was to use your old spring instead of the one that comes in this one

  9. TheSamba.com :: VW Classifieds - Parts - General Parts

    www.thesamba.com/vw/classifieds//cat.php?id=21

    Radio Parts: 10 Today 3:51 am USA - Heist op den Berg, Outside the USA Seller: veluc: Ivory Fog Light Switch With Red Indicator Light: 199 Today 3:51 am USA - Heist op den Berg, Outside the USA Seller: veluc: NOS Ivory Switch: 95 Today 3:51 am USA - Heist op den Berg, Outside the USA Seller: veluc: Hella Le Mans 140: 120 Today 3:51 am

  10. VW Classifieds - Parts - Type 2/Bus - Vanagon - TheSamba.com

    www.thesamba.com/vw/classifieds/cat.php?id=57

    VW Bus Vanagon Parts. 250. Yesterday 8:00 pm USA - Las Vegas, Nevada Map Seller: lee dagger. Distributor Condenser Bosch (02 061) $16.302. Yesterday 7:39 pm USA - HOUSTON, Texas Map Seller: heimlich. NOS Piston Cylinder Mahle (021 198 075 B) Brazil. $112.2. Yesterday 7:28 pm USA - HOUSTON, Texas Map Seller: heimlich.

  11. Buyer and Seller Feedback - View topic - TheSamba.com

    www.thesamba.com/vw/forum/viewtopic.php?p=4205891

    I paid for the extra shipping so I could have the parts this weekend. Luckily, the parts were not damaged. I've never had any issues with CIP-1 other than recieving damaged parts which they have always made right. Two suggestions to this company if they happen to read this- 1- I think they need to get better boxes and package the parts better.