Search results
Results From The WOW.Com Content Network
List of gear nomenclature. This page lists the standard US nomenclature used in the description of mechanical gear construction and function, together with definitions of the terms. The terminology was established by the American Gear Manufacturers Association (AGMA), under accreditation from the American National Standards Institute (ANSI).
The Hondamatic incorporated a lockup function, which Honda called a third ratio, and had manual gear selection. The company's early transmissions also used a patented torque converter which used stator force to reduce hydraulic losses by using a reaction arm to increase the hydraulic pressure when the stator was stalled. The reaction arm acted ...
5MT. This was the only five-speed 4WD transmission made for the Subaru Leone. Gear Ratios: 1st 3.545 2nd 1.947 3rd 1.366 4th .972 5th .780, Rev 3.416 Low Range 1.59. Usage: 1985–1994 Subaru Leone and 1985–1989 Subaru XT 1800cc.
The 4L80-E (and similar 4L85-E) is a series of automatic transmissions from General Motors. Designed for longitudinal engine configurations, the series included 4 forward gears. It was the 4-speed electronically commanded evolution of the 3-speed Turbo-Hydramatic 400, first produced in October 1963. 4L80-Es were optioned only in Chevrolet/GMC ...
L-series (HSD) The L-series (HSD) are Hybrid Synergy Drive transmissions used in Toyota and Lexus hybrids for RWD-based platforms. [ 4] Models: L310 Crown Hybrid 3.5L (2018-2022), Lexus LC500h (2018-), LS500h (2018-) - combines HSD with a 4-speed planetary gearset. Has pre-programmed 10-Speed shifts.
A gear[ 1][ 2] or gearwheel[ 3][ 4][ 5] is a rotating machine part typically used to transmit rotational motion and/or torque by means of a series of teeth that engage with compatible teeth of another gear or other part. The teeth can be integral saliences or cavities machined on the part, or separate pegs inserted inserted into it.
Borg-Warner T-56 transmission. The T-56 six speed manual transmission has been used in a wide range of vehicles from General Motors, Dodge, and Ford Motor Company. The transmission was originally designed and built by BorgWarner for the Dodge Viper later being used by GM in 1992 for the generation II and later engines, but from 1998 was built ...
This design allows the vehicle to be driven (in “limp-in” mode) in the event of an electronic control system failure, or a situation that the Transmission Control Module (TCM) recognizes as potentially damaging to the transmission. On the 68RFE, fourth gear is used for limp-in instead of second and third. All RFE transmissions use Mopar ATF +4.