Search results
Results From The WOW.Com Content Network
A line array is a loudspeaker system that is made up of a number of usually identical loudspeaker elements mounted in a line and fed in phase, to create a near-line source of sound. The distance between adjacent drivers is close enough that they constructively interfere with each other to send sound waves farther than traditional horn-loaded ...
In its original formulation, Ambisonics assumed plane-wave sources for reproduction, which implies speakers that are infinitely far away. This assumption will lead to a pronounced bass boost for speaker rigs of small diameter, which increases with Ambisonic order. The cause is the very same proximity effect that occurs with directional microphones.
Digital Sound System 80. The Digital Sound System 80, short DSS80, was a three-piece PC audio system co-developed by Microsoft and Philips. It debuted on the 1998 Electronic Entertainment Expo (E³) and is most likely the only speaker system ever released by the Microsoft Corporation. It also remains one of the very few featuring Philips' wOOx ...
These Basic Earbuds. The Work Earbuds Classic. Raycon. For everyday wear that’s easy to take in and out, these buds are the perfect pick! See it! Get The Work Earbuds Classic (originally $120 ...
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
The SB-1 was designed to direct 100 dB SPL 500 feet (152 m), or 116 dB SPL 420 feet (128 m), depending on atmospheric conditions, and so eliminate the need for delay speakers. [2] [9] In 2002, Meyer Sound produced the SB-2, a bi-amplified loudspeaker which uses a parabolic dish as the front face of the enclosure.
RCA bass reflex shelf stereo speakers. A bass reflex system (also known as a ported, vented box or reflex port) is a type of loudspeaker enclosure that uses a port (hole) or vent cut into the cabinet and a section of tubing or pipe affixed to the port. [1][2] This port enables the sound from the rear side of the diaphragm to increase the ...
A speaker enclosure using a passive radiator usually contains an "active loudspeaker " (or main driver), and a passive radiator (also known as a "drone cone"). The active loudspeaker is a normal driver, and the passive radiator is of similar construction, but without a voice coil and magnet assembly. It is not attached to a voice coil or wired ...