Search results
Results From The WOW.Com Content Network
A relay valve is an air-operated valve typically used in air brake systems to remotely control the brakes at the rear of a heavy truck or semi-trailer in a tractor-trailer combination. Relay valves are necessary in heavy trucks in order to speed-up rear-brake application and release, since air takes longer to travel to the rear of the vehicle ...
The Sensotronic Brake Control (SBC) system operates using a hydraulic high-pressure reservoir to supply brake fluid. A piston pump, driven by an electric motor, generates controlled brake fluid pressure ranging between 140 bars (2,000 psi) and 160 bars (2,300 psi) in the gas diaphragm reservoir.
The parking brake is the air operated spring brake type where the brake is applied by spring force in the spring brake cylinder (12) and released by compressed air via a hand-control valve (7). The trailer brake consists of a direct two-line system: the supply line and the separate control or service line.
Pneumatic valve springs. Pneumatic valve springs are metal bellows filled with compressed air [ 1] used as an alternative to the metal wire springs used to close valves in high-speed internal combustion engines. This system was introduced in Formula One in 1986 with the Renault EF-Type .
When the compressor is operated the shuttle valves direct air to open the brake shoes. When the control valve is centered, the brake cylinder is vented through the shuttle valve, and the brake shoes are allowed to close. [clarification needed] Air pilot control: converting from air to oil results in locking of the cylinder.
When the brake pipe and car components are charged with air, the brakes release. When the engineer needs to make a brake application, control valves in the locomotive reduce the brake pipe pressure. As the brake pipe pressure is reduced, the service portions on each car divert air from their reservoirs to their brake cylinders.
Code 1: A time critical event with response requiring lights and siren. This usually is a known and going fire or a rescue incident. Code 2: Unused within the Country Fire Authority. Code 3: Non-urgent event, such as a previously extinguished fire or community service cases (such as animal rescue or changing of smoke alarm batteries for the ...
In electric power systems and industrial automation, ANSI Device Numbers can be used to identify equipment and devices in a system such as relays, circuit breakers, or instruments. The device numbers are enumerated in ANSI / IEEE Standard C37.2 Standard for Electrical Power System Device Function Numbers, Acronyms, and Contact Designations .