Search results
Results From The WOW.Com Content Network
Harmonic balancer lower pulley on a four-cylinder engine. A harmonic damper is a device fitted to the free (accessory drive) end of the crankshaft of an internal combustion engine to counter torsional and resonance vibrations from the crankshaft. This device must be an interference fit to the crankshaft in order to operate in an effective manner.
Damper winding. Bars and rings of the damper (amortisseur) winding of an AC generator (General Electric, early 20th century). Note the gaps in the cage along the quadrature axes. The damper winding (also amortisseur winding[1]) is a squirrel-cage -like winding on the rotor of a typical synchronous electric machine.
A dashpot, also known as a damper[citation needed], is a mechanical device that resists motion via viscous friction. [1] The resulting force is proportional to the velocity, but acts in the opposite direction, [2] slowing the motion and absorbing energy. It is commonly used in conjunction with a spring. The process and instrumentation diagram ...
W. H. Allen Co. Original York Street, Lambeth Works in 1880. The Company, initially known as W. H. Allen & Co was founded in 1880 by William Henry Allen as a manufacturer of centrifugal pumps and steam engines in York Street, Lambeth, London. [1] [2] Electric light generating machinery followed with the support of Gisbert Kapp.
An advertisement for Allen safety screws would appear in the 1910 Annual Convention of International Association of Factory Inspectors. [6] In 1922, Allen Manufacturing Company produced sets of tools under the company name "Bay State", suggesting that they may have privately acquired another hardware manufacturer, namely the Bay State Pump Company.
The term "hex key" is best known as "Allen" in the English-speaking countries like the UK, Australia, Canada and the U.S. and in Spanish-speaking countries such as Spain and Mexico (The "Allen" name is a registered trademark, originated by the Allen Manufacturing Company of Hartford, Connecticut circa 1910, [1] now owned by Apex Tool Group, LLC ...
A business using a part will often use a different part number than the various manufacturers of that part do. This is especially common for catalog hardware, because the same or similar part design (say, a screw with a certain standard thread, of a certain length) might be made by many corporations (as opposed to unique part designs, made by only one or a few).
A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process. In the process industry, a standard set of symbols is used to prepare drawings of processes. The instrument symbols used in these drawings are generally based on ...