Search results
Results From The WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
12 ft. Metric ( SI) units. 25.4 mm. A fire hydrant marked as 3-inch. The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to ...
Where P is the power in airwatts, F is the rate per minute (denoted cu ft/min or CFM) and S is the suction capacity expressed as a pressure in units of inches of water. Some manufacturers choose to use the fraction 1 ⁄ 8.5 rather than the ASTM decimal, leading to a less than 0.25% variation in their calculations.
The typical range lies between 1 ⁄ 2 to 2 ⁄ 3 inch (12.7 to 16.9 mm) for the UK/US size system and 4 ⁄ 3 to 5 ⁄ 3 cm (13.3 to 16.7 mm) for the European size system, but may extend to 1 ⁄ 4 to 3 ⁄ 4 inch (6.4 to 19.1 mm) and 2 ⁄ 3 to 6 ⁄ 3 cm (6.7 to 20.0 mm).
Horizontal pitch (HP) is a unit of length defined by the Eurocard printed circuit board standard used to measure the horizontal width of rack mounted electronic equipment, similar to the rack unit (U) used to measure vertical heights of rack mounted equipment. One HP is 0.2 inches (1/5") or 5.08 millimetres wide.
Thickness of aluminum foil is measured in mils (1 ⁄ 1000 inch, or 0.0254 mm) in the United States. Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in ...
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [ 27 ] [ 33 ] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry.