Search results
Results From The WOW.Com Content Network
IC power-supply pin. IC power-supply pins denote a voltage and current supply terminals in electric, electronics engineering, and in integrated circuit design. [a] Integrated circuits (ICs) have at least two pins that connect to the power rails of the circuit in which they are installed. These are known as the power-supply pins.
Intel 8237A-5, used on the original IBM PC motherboard. Pinout. Intel 8237 is a direct memory access (DMA) controller, a part of the MCS 85 microprocessor family. It enables data transfer between memory and the I/O with reduced load on the system's main processor by providing the memory with control signals and memory address information during the DMA transfer.
The first part number in the series, the 7400, is a 14-pin IC containing four two-input NAND gates. Each gate uses two input pins and one output pin, with the remaining two pins being power (+5 V) and ground. This part was made in various through-hole and surface-mount packages, including flat pack and plastic/ceramic dual in-line.
The Intel 8259 is a programmable interrupt controller (PIC) designed for the Intel 8085 and 8086 microprocessors. The initial part was 8259, a later A suffix version was upward compatible and usable with the 8086 or 8088 processor. The 8259 combines multiple interrupt input sources into a single interrupt output to the host microprocessor ...
The 8255 has a similar function to the Motorola 6820 PIA (Peripheral Interface Adapter) from the Motorola 6800 family, also originally packaged as 40-pin DIL. The 8255 provides 24 I/O pins with four programmable direction bits: one for Port A(7:0) (i.e., all pins in the port), one for Port B(7:0), one for Port C(3:0) and one for Port C(7:4).
Open collector, open drain, open emitter, and open source refer to integrated circuit (IC) output pin configurations that process the IC's internal function through a transistor with an exposed terminal that is internally unconnected (i.e. "open"). One of the IC's internal high or low voltage rails typically connects to another terminal of that ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
74181. The 74S181 4-bit ALU bitslice resting on a page from the datasheet. The 74181 is a 4-bit slice arithmetic logic unit (ALU), implemented as a 7400 series TTL integrated circuit. Introduced by Texas Instruments in February 1970, [ 1] it was the first complete ALU on a single chip. [ 2] It was used as the arithmetic/logic core in the CPUs ...