Search results
Results From The WOW.Com Content Network
For model year 2000 - 2004 trucks, the F-150 7700 offered this axle and the F-250 light duty was discontinued. At least till 2011 the 12 bolt semi float was still found with the heavy duty f-150. Gear ratios were 3.73 in 4x4 and either the 3.73 or 4.10 in the two-wheel-drive models. This was available in both limited slip and standard variations.
Differential (mechanical device) A differential is a gear train with three drive shafts that has the property that the rotational speed of one shaft is the average of the speeds of the others. A common use of differentials is in motor vehicles, to allow the wheels at each end of a drive axle to rotate at different speeds while cornering.
The Corvette above is equipped with a differential that has a final drive ratio (or axle ratio) of 3.42:1, meaning that for every 3.42 revolutions of the transmission's output, the wheels make one revolution. The differential ratio multiplies with the transmission ratio, so in 1st gear, the engine makes 10.16 (= 2.97 × 3.42) revolutions for ...
List of gear nomenclature. This page lists the standard US nomenclature used in the description of mechanical gear construction and function, together with definitions of the terms. The terminology was established by the American Gear Manufacturers Association (AGMA), under accreditation from the American National Standards Institute (ANSI).
The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door stickers. They differ greatly from previous Dana 70 front axles, some of the major differences being the use of 1550 Universal Joints and being a high pinion, reverse cut axle.
The initial design of the GM 10.5" 14-bolt differential spanned from 1973 to 1984, remaining unaltered until 1986. This iteration featured brake drums secured by wheel studs and utilized a smaller diameter pinion bearing compared to the subsequent design. The second design, in production since 1986, introduced notable improvements.
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60. It can be readily identified by its straight axle tubes, 10 bolt asymmetrical cover, and ...
5MT. This was the only five-speed 4WD transmission made for the Subaru Leone. Gear Ratios: 1st 3.545 2nd 1.947 3rd 1.366 4th .972 5th .780, Rev 3.416 Low Range 1.59. Usage: 1985–1994 Subaru Leone and 1985–1989 Subaru XT 1800cc.