Ads
related to: 12 volt battery charging time calculator charger circuit tester
Search results
Results From The WOW.Com Content Network
Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger.
If a battery has been completely discharged (e.g. the car lights were left on overnight) and next is given a fast charge for only a few minutes, then during the short charging time it develops only a charge near the interface. The battery voltage may rise to be close to the charger voltage so that the charging current decreases significantly.
Trickle charging. Trickle charging means charging a fully charged battery at a rate equal to its self-discharge rate, thus enabling the battery to remain at its fully charged level; this state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.
State of charge. State of charge ( SoC) quantifies the remaining capacity available in a battery at a given time and in relation to a given state of ageing. [1] It is usually expressed as percentage (0% = empty; 100% = full). An alternative form of the same measure is the depth of discharge ( DoD), calculated as 1 − SoC (100% = empty; 0% = full).
IUoU is a DIN -designation [1] (DIN 41773) for a lead-acid battery charging procedure that is also known as 3-stage charging, 3-phase charging, or 3-step charging. It consists of three phases (or stages), to be executed by a battery charger. The three phases are: I-phase (constant electric current ), Uo-phase (constant over- voltage ), and U ...
A battery management system ( BMS) is any electronic system that manages a rechargeable battery ( cell or battery pack) by facilitating the safe usage and a long life of the battery in practical scenarios while monitoring and estimating its various states (such as SoH, and SoC ), [1] calculating secondary data, reporting that data, controlling ...
Pre-charge. Peak inrush current into a high voltage capacitor upon power up can stress the component, reducing its reliability. Pre-charge of the powerline voltages in a high voltage DC application is a preliminary mode which limits the inrush current during the power up procedure. A high-voltage system with a large capacitive load can be ...
Battery charger. Charging a 12 V lead-acid car battery. A mobile phone plugged in to an AC adapter for charging. A battery charger, recharger, or simply charger, [1] [2] is a device that stores energy in an electric battery by running current through it. The charging protocol—how much voltage, current, for how long and what to do when ...
Ads
related to: 12 volt battery charging time calculator charger circuit tester