Net Deals Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Identification friend or foe - Wikipedia

    en.wikipedia.org/wiki/Identification_friend_or_foe

    Identification, friend or foe ( IFF) is a combat identification system designed for command and control. It uses a transponder that listens for an interrogation signal and then sends a response that identifies the broadcaster. IFF systems usually use radar frequencies, but other electromagnetic frequencies, radio or infrared, may be used. [ 1]

  3. IFF Mark X - Wikipedia

    en.wikipedia.org/wiki/IFF_Mark_X

    The original design had three such "modes", Mode 1 was triggered by the interrogator by sending the two pulses 3 μs apart (±0.2 μs), Mode 2 was 5 μs and Mode 3 was 8 μs. [ 10 ] The response to these interrogations remained simple; a successful interrogation on Mode 1 or 3 caused a single pulse to be sent in reply, very shortly after the ...

  4. Aviation transponder interrogation modes - Wikipedia

    en.wikipedia.org/wiki/Aviation_transponder...

    Provides 4-digit octal unit code (set on ground for fighters, can be changed in flight by transport aircraft) [1] 3: A: Provides a 4-digit octal identification code for the aircraft, set in the cockpit but assigned by the air traffic controller. Mode 3/A is often combined with Mode C to provide altitude information as well. [2] C

  5. Air traffic control radar beacon system - Wikipedia

    en.wikipedia.org/wiki/Air_traffic_control_radar...

    Mode 3/A is used to identify each aircraft in the radar's coverage area. Mode C is used to request/report an aircraft's altitude. Two other modes, mode 4 and mode S, are not considered part of the ATCRBS system, but they use the same transmit and receive hardware. Mode 4 is used by military aircraft for the Identification Friend or Foe (IFF ...

  6. List of transponder codes - Wikipedia

    en.wikipedia.org/wiki/List_of_Transponder_Codes

    Non-discrete mode A code reserved use in mode S radar/ADS-B environment where the aircraft identification will be used to correlate the flight plan instead of the mode A code. [1] US: Used exclusively by ADS-B aircraft to inhibit mode 3A transmission. [3] US: Non-discrete code assignments in accordance with FAA Order JO 7110.65, 5-2.

  7. Gillham code - Wikipedia

    en.wikipedia.org/wiki/Gillham_Code

    Gillham code is a zero-padded 12-bit binary code using a parallel nine- [ 1] to eleven-wire interface, [ 2] the Gillham interface, that is used to transmit uncorrected barometric altitude between an encoding altimeter or analog air data computer and a digital transponder. It is a modified form of a Gray code and is sometimes referred to simply ...

  8. Secondary surveillance radar - Wikipedia

    en.wikipedia.org/wiki/Secondary_surveillance_radar

    Secondary surveillance radar antenna (flat rectangle, top) mounted on an ASR-9 primary airport surveillance radar antenna (curved rectangle, bottom).. The need to be able to identify aircraft more easily and reliably led to another wartime radar development, the Identification Friend or Foe (IFF) system, which had been created as a means of positively identifying friendly aircraft from unknowns.

  9. Tel-Instrument Announces DoD AIMS Program Office ... - AOL

    www.aol.com/news/2013-03-14-tel-instrument...

    Tel-Instrument Announces DoD AIMS Program Office Certification on the TS-4530A Mode 5 IFF Flight-Line Test Set Production Contracts Now In Place to Fully Satisfy the Mode 5 Testing Requirements of ...