Net Deals Web Search

Search results

1. Results From The WOW.Com Content Network

2. SCSI connector - Wikipedia

   en.wikipedia.org/wiki/SCSI_connector

   SCSI hard drives showing 80-pin SCA connector (top), and separate 68-pin and power connectors plus configuration jumpers (bottom) SCSI backplane with 80-pin SCA connectors. Hard Drives are mounted on proprietary hot-swappable caddies. Single Connector Attachment, or SCA, is a type of connection for the internal cabling of Parallel SCSI systems ...

3. Hard disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Hard_disk_drive_interface

   Early interfaces. A data cable (top) and control cable (below) connecting a controller card and an ST-506 type HDD. Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data.

4. SCSI - Wikipedia

   en.wikipedia.org/wiki/SCSI

   ANSI X3.131-1986, June 1986. Produced. Since 1983. Small Computer System Interface ( SCSI, / ˈskʌzi / SKUZ-ee) [ 2] is a set of standards for physically connecting and transferring data between computers and peripheral devices, best known for its use with storage devices such as hard disk drives. SCSI was introduced in the 1980s and has seen ...

5. SATA - Wikipedia

   en.wikipedia.org/wiki/SATA

   A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...

6. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   Molex Mini-Fit Jr. connector as used for ATX power supply. A Molex connector is a two-piece pin-and-socket interconnection which became an early electronic standard. Developed by Molex Connector Company in the late 1950s, the design features cylindrical spring-metal pins that fit into cylindrical spring-metal sockets, both held in a rectangular ...

7. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   After IBM introduced the "twist" to floppy cables, and when both 5.25-inch and 3.5-inch drives were in common use, many cables had four connectors: one of each type before the twist, and one of each type after the twist. These cables still only supported two drives, one before and one after the twist, but they allowed using one cable for any ...