Search results
Results From The WOW.Com Content Network
2011 Chrysler 200 touring 2.4L and I believe 6 speed auto trans. Not really any major issues and no lights for checking engine. Just recently got the car and had a shop do a 13 point inspection checking fluids and what not(so they say) everything checked good, they looked at carfax as well, said everything has been well maintenanced.
2012 Chrysler 200 limited cranks but no start. When I turn the key it'll crank but it won't start. The fuel pump has power, the starter has power. When testing if tipm The fuses in the slides for 23, 25, 26 have no power. We need to turn the key to the ON position they have power and immediately dies afterwards.
The oil pressure sensor (2) is located on the oil filter housing (3). The oil pressure sensor is a three wire sensor with a tapered threaded sensor port. The sensor port is mounted to the oil filter housing through an access hole. A thread lock patch seals the oil pressure sensor to the oil filter housing. The repair procedure says you need to ...
I replaced my brakes and rotors on my 2012 Chrysler 200 Limited sedan. As soon I started driving, I felt the ABS kick in. When stepping on the brakes, they were pumping as if I were sliding, but the weather was sunny. Then that is when the two lights turned on. Every time I turn the car on, the lights will turn off. Then the ABS tries to kick it.
597 posts · Joined 2013. #2 · Jul 10, 2017. Here's what I could find. The engine is equipped with four heated oxygen sensors: [h=4] [/h] The right upstream oxygen sensor (1) is referred to as the 1/1 sensor. The right downstream oxygen sensor (4) is referred to as the 1/2 sensor. The left upstream oxygen sensor (3) is referred to as the 2/1 ...
At 10 years old, it is due for a flush. 2012 may have been the last year that Chrysler used HOAT coolant. Use distilled or very soft water for the fill. Make sure that the coolant you use says that it meets Chrysler MS-9769. You might consider a 'power back-flush' to force any loose corrosion out of the heater core.
You might want to try the Sebring/200 convertible forum. * Chrysler Sebring / 200 Convertible Club * I have a 2012 200 convertible but I don't have an answer for your question. There are ways for service techs to manually lower a stuck top. I found the following in the owner's manual regarding emergency operation of the top....
Good afternoon! I currently have a P0882 DTC on my [2012 Chrysler 200 - 2.4L] .. P0882 - TCM Power Input Signal Low. Googling says that it means the voltage going to the transmission control module is low, so we were speculating we would need to look at the wires going to the TCM or maybe cleaning the contact points between the TCM & everything ...
HVAC vent calibration. A couple years ago, I replaced the recirculation door actuator on my 2012 200, first pulling the vent direction actuator by mistake. Since then, my vents haven't been directing air to where I have the vent knob pointed. My 200 has a single-zone automatic climate control system, and I've read stuff all over the internet ...
2012 Chrysler 200 wiper washer fuse. I have purchased a 2012 Chrysler 200 Limited, and recently discovered the windshield washer motor is not functional. It does not make noise at all when I trigger the pull, there is fluid in the reservoir. I want to check the fuse for that but I am getting conflicting search results about if there is a fuse ...