Search results
Results From The WOW.Com Content Network
ping is a computer network administration software utility used to test the reachability of a host on an Internet Protocol (IP) network. It is available for virtually all operating systems that have networking capability, including most embedded network administration software. Ping measures the round-trip time for messages sent from the ...
The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination. The sum of the mean times in each hop is a measure of the total time spent to establish the connection. The command aborts if all (usually three) sent packets are lost more than twice.
Round-trip delay. In telecommunications, round-trip delay ( RTD) or round-trip time ( RTT) is the amount of time it takes for a signal to be sent plus the amount of time it takes for acknowledgement of that signal having been received. This time delay includes propagation times for the paths between the two communication endpoints. [1]
PathPing. The PathPing command is a command-line network utility included in Windows NT operating systems since Windows 2000 that combines the functionality of ping with that of tracert. [1] It is used to locate spots that have network latency and network loss. [2] [3]
Ping time. Ping time is the network delay for a round trip between a player's client and the game server as measured with the ping utility or equivalent. Ping time is an average time measured in milliseconds (ms). [citation needed] The lower one's ping is, the lower the latency is and the less lag the player will experience.
Then, the command ipconfig /renew is executed to request a new IP address. [3] [4] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is taken ...
A command prompt (or just prompt) is a sequence of (one or more) characters used in a command-line interface to indicate readiness to accept commands. It literally prompts the user to take action. A prompt usually ends with one of the characters $ , % , # , [10] [11] : , > or - [12] and often includes other information, such as the path of the ...
PING. Syntax: PING <server1> [<server2>] Tests the presence of a connection. A PING message results in a PONG reply. If <server2> is specified, the message gets passed on to it. Defined in RFC 1459. PONG. Syntax: PONG <server1> [<server2>] This command is a reply to the PING command and works in much the same way. Defined in RFC 1459.