Search results
Results From The WOW.Com Content Network
Decimal: 9 1. Binary : 1001 0001. Hence the numerical range for one unpacked BCD byte is zero through nine inclusive, whereas the range for one packed BCD byte is zero through ninety-nine inclusive. To represent numbers larger than the range of a single byte any number of contiguous bytes may be used.
The Aiken code (also known as 2421 code) [1] [2] is a complementary binary-coded decimal (BCD) code. A group of four bits is assigned to the decimal digits from 0 to 9 according to the following table. The code was developed by Howard Hathaway Aiken and is still used today in digital clocks, pocket calculators and similar devices [citation ...
The most significant digit is an exception to this: for an n-bit Gray code, the most significant digit follows the pattern 2 n-1 on, 2 n-1 off, which is the same (cyclic) sequence of values as for the second-most significant digit, but shifted forwards 2 n-2 places. The four-bit version of this is shown below:
Chen–Ho encoding is a memory-efficient alternate system of binary encoding for decimal digits.. The traditional system of binary encoding for decimal digits, known as binary-coded decimal (BCD), uses four bits to encode each digit, resulting in significant wastage of binary data bandwidth (since four bits can store 16 states and are being used to store only 10), even when using packed BCD.
The Intel BCD opcodes are a set of six x86 instructions that operate with binary-coded decimal numbers. The radix used for the representation of numbers in the x86 processors is 2. This is called a binary numeral system. However, the x86 processors do have limited support for the decimal numeral system . In addition, the x87 part supports a ...
Binary decoder. In digital electronics, a binary decoder is a combinational logic circuit that converts binary information from the n coded inputs to a maximum of 2 n unique outputs. They are used in a wide variety of applications, including instruction decoding, data multiplexing and data demultiplexing, seven segment displays, and as address ...
Double dabble. In computer science, the double dabble algorithm is used to convert binary numbers into binary-coded decimal (BCD) notation. [1] [2] It is also known as the shift-and-add -3 algorithm, and can be implemented using a small number of gates in computer hardware, but at the expense of high latency. [3]
BCD ( binary-coded decimal ), also called alphanumeric BCD, alphameric BCD, BCD Interchange Code, [1] or BCDIC, [1] is a family of representations of numerals, uppercase Latin letters, and some special and control characters as six-bit character codes . Unlike later encodings such as ASCII, BCD codes were not standardized.