Search results
Results From The WOW.Com Content Network
The gas/oil ratio (GOR) is the ratio of the volume of gas ("scf") that comes out of solution to the volume of oil — at standard conditions. In reservoir simulation gas/oil ratio is usually abbreviated . A point to check is whether the volume of oil is measured before or after the gas comes out of solution, since the remaining oil volume will ...
The reserves-to-production ratio ( RPR or R/P) is the remaining amount of a non-renewable resource, expressed in time. While applicable to all natural resources, the RPR is most commonly applied to fossil fuels, particularly petroleum and natural gas. The reserve portion ( numerator) of the ratio is the amount of a resource known to exist in an ...
The steam to oil ratio is a measure of the water and energy consumption related to oil production in cyclic steam stimulation and steam assisted gravity drainage oil production. SOR is the ratio of unit of steam required to produce unit of Oil. The typical values are three to eight and two to five respectively. This means two to eight barrels ...
The partition coefficient, abbreviated P, is defined as a particular ratio of the concentrations of a solute between the two solvents (a biphase of liquid phases), specifically for un- ionized solutes, and the logarithm of the ratio is thus log P. [ 10]: 275ff When one of the solvents is water and the other is a non-polar solvent, then the log ...
Turndown ratio refers to the width of the operational range of a device, and is defined as the ratio of the maximum capacity to minimum capacity. For example, a device with a maximum output of 10 units and a minimum output of 2 units has a turndown ratio of 5. The term is commonly used with measurement devices and combustion plant like boilers ...
In a nozzle or other constriction, the discharge coefficient (also known as coefficient of discharge or efflux coefficient) is the ratio of the actual discharge to the ideal discharge, [1] i.e., the ratio of the mass flow rate at the discharge end of the nozzle to that of an ideal nozzle which expands an identical working fluid from the same initial conditions to the same exit pressures.
Barrel of oil equivalent. The barrel of oil equivalent ( BOE) is a unit of energy based on the approximate energy released by burning one barrel (42 US gallons, 35 imp gal or about 159 litres) of crude oil. The BOE is used by oil and gas companies in their financial statements as a way of combining oil and natural gas reserves and production ...
The compression ratio is the ratio between the volume of the cylinder and combustion chamber in an internal combustion engine at their maximum and minimum values. A fundamental specification for such engines, it is measured two ways: the static compression ratio, calculated based on the volume of the cylinder when the piston is at the bottom of ...