Search results
Results From The WOW.Com Content Network
Travoprost. Travoprost, sold under the brand name Travatan among others, is a medication used to treat high pressure inside the eye including glaucoma. [4] Specifically it is used for open angle glaucoma when other agents are not sufficient. [5] [4] It is used as an eye drop. [4] Effects generally occur within two hours.
The general relationship between absorbed dose and equivalent dose can be represented as. H = Q ⋅ D. where H is the equivalent dose, D is the absorbed dose, and Q is a dimensionless quality factor. Thus, for any quantity of D measured in Gy, the numerical value for H measured in Sv may be different.
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: feq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c (H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
Standard normal table. In statistics, a standard normal table, also called the unit normal table or Z table, [1] is a mathematical table for the values of Φ, the cumulative distribution function of the normal distribution. It is used to find the probability that a statistic is observed below, above, or between values on the standard normal ...
Compressibility factor values are usually obtained by calculation from equations of state (EOS), such as the virial equation which take compound-specific empirical constants as input. For a gas that is a mixture of two or more pure gases (air or natural gas, for example), the gas composition must be known before compressibility can be calculated.
The Official Table of Drops, formerly issued by the British Home Office, is a manual which is used to calculate the appropriate length of rope for long drop hangings . Following a series of failed hangings, including those of John Babbacombe Lee, a committee chaired by Henry Bruce, 1st Baron Aberdare was formed in 1886 to discover and report on ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
A simplified version of the definition is: The k v factor of a valve indicates "The water flow in m 3 /h, at a pressure drop across the valve of 1 kgf/cm 2 when the valve is completely open. The complete definition also says that the flow medium must have a density of 1000 kg/m 3 and a kinematic viscosity of 10 −6 m 2 /s , e.g. water.