Net Deals Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Identification friend or foe - Wikipedia

    en.wikipedia.org/wiki/Identification_friend_or_foe

    Identification friend or foe. Identification, friend or foe ( IFF) is a combat identification system designed for command and control. It uses a transponder that listens for an interrogation signal and then sends a response that identifies the broadcaster. IFF systems usually use radar frequencies, but other electromagnetic frequencies, radio ...

  3. Aviation transponder interrogation modes - Wikipedia

    en.wikipedia.org/wiki/Aviation_transponder...

    Mode 3/A is often combined with Mode C to provide altitude information as well. [2] C: Provides the aircraft's pressure altitude and is usually combined with Mode 3/A to provide a combination of a 4-digit octal code and altitude as Mode 3 A/C, often referred to as Mode A and C [2] 4: Provides a 3-pulse reply, delay is based on the encrypted ...

  4. IFF Mark X - Wikipedia

    en.wikipedia.org/wiki/IFF_Mark_X

    To ensure the emergency code would be picked up by most interrogators, the operator would set the IFF to emergency and dial 77, thus responding with the same set of pulses on both Mode 1 and 3. [15] The longer response in Mode 2 was used solely by military users, [b] allowing them to identify individual aircraft. The four digits provided a ...

  5. Air traffic control radar beacon system - Wikipedia

    en.wikipedia.org/wiki/Air_traffic_control_radar...

    Mode 3/A is used to identify each aircraft in the radar's coverage area. Mode C is used to request/report an aircraft's altitude. Two other modes, mode 4 and mode S, are not considered part of the ATCRBS system, but they use the same transmit and receive hardware. Mode 4 is used by military aircraft for the Identification Friend or Foe (IFF ...

  6. List of transponder codes - Wikipedia

    en.wikipedia.org/wiki/List_of_Transponder_Codes

    Non-discrete mode A code reserved use in mode S radar/ADS-B environment where the aircraft identification will be used to correlate the flight plan instead of the mode A code. [1] US: Used exclusively by ADS-B aircraft to inhibit mode 3A transmission. [3] US: Non-discrete code assignments in accordance with FAA Order JO 7110.65, 5-2.

  7. Gillham code - Wikipedia

    en.wikipedia.org/wiki/Gillham_Code

    Gillham code is a zero-padded 12-bit binary code using a parallel nine- [ 1] to eleven-wire interface, [ 2] the Gillham interface, that is used to transmit uncorrected barometric altitude between an encoding altimeter or analog air data computer and a digital transponder. It is a modified form of a Gray code and is sometimes referred to simply ...

  8. Transponder (aeronautics) - Wikipedia

    en.wikipedia.org/wiki/Transponder_(aeronautics)

    The green IDENT button is marked "ID". A transponder (short for trans mitter-res ponder[ 1] and sometimes abbreviated to XPDR, [ 2] XPNDR, [ 3] TPDR [ 4] or TP [ 5]) is an electronic device that produces a response when it receives a radio-frequency interrogation. Aircraft have transponders to assist in identifying them on air traffic control ...

  9. Tel-Instrument Announces DoD AIMS Program Office ... - AOL

    www.aol.com/news/2013-03-14-tel-instrument...

    Tel-Instrument Announces DoD AIMS Program Office Certification on the TS-4530A Mode 5 IFF Flight-Line Test Set Production Contracts Now In Place to Fully Satisfy the Mode 5 Testing Requirements of ...