Net Deals Web Search

Search results

1. Results From The WOW.Com Content Network

2. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   Rigid copper is a popular choice for water lines. Rigid or "Hard" copper tubing is generally referred to as "pipe". Copper "piping" is referred to by nominal pipe size, or the inner diameter. It is joined using a solder/sweat, roll grooved, compression, or crimped/pressed connection. Rigid copper, rigid due to the work hardening of the drawing ...

3. Copper in heat exchangers - Wikipedia

   en.wikipedia.org/wiki/Copper_in_heat_exchangers

   The most efficient ground source heat pumps use ACR, Type L or special-size copper tubing buried into the ground to transfer heat to or from the conditioned space. Flexible copper tube (typically 1/4-inch to 5/8-inch) can be buried in deep vertical holes, horizontally in a relatively shallow grid pattern, in a vertical fence-like arrangement in ...

4. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   The difference between pipes and tubes is a matter of sizing. For instance, PVC pipe for plumbing applications and galvanized steel pipe are measured in iron pipe size (IPS). Copper tube, CPVC, PeX and other tubing is measured nominally, basically an average diameter. These sizing schemes allow for universal adaptation of transitional fittings.

5. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

6. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   Flare fittings are a type of compression fitting used with metal tubing, usually soft steel, ductile (soft) copper and aluminum, though other materials are also used. In a flare fitting the tube itself is "flared" i.e. expanded and deformed at the end. The flare is then pressed against the fitting it connects to and is secured by a close ...

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Copper fittings for soldered joints. Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...