Ads
related to: 1/2 inch to mm socket
Search results
Results From The WOW.Com Content Network
British Morris and MG engines from 1923 to 1955 were built using metric threads with bolt heads and nuts dimensioned for Whitworth spanners and sockets. [13] In 1919, Morris Motors took over the French Hotchkiss engine works which had moved to Coventry during the First World War.
Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
These "extend" the length of the socket and allow access to nuts or bolts that are difficult to reach. Extensions are typically 1 ⁄ 2 to 20 inches (15 to 510 mm) in length in roughly 1-to-3-inch (25 to 75 mm) increments. They are sometimes attached together to get a needed length extension, and often have a knurled section for added grip.
The US military uses a variety of phone connectors including 9 ⁄ 32-inch (0.281-inch, 7.14 mm) and 1 ⁄ 4-inch (0.25 inch, 6.35 mm) diameter plugs. [38] Commercial and general aviation (GA) civil aircraft headsets often use a pair of phone connectors. A standard 1 ⁄ 4-inch (6.3
British Standard Pipe ( BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external ( male) thread with an internal (female) thread. It has been adopted as standard in plumbing and pipe fitting, except in North America, where NPT and ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
PZ1 is normally used on screw diameters from 2–3 mm, PZ2 from 3.5–5 mm and PZ3 from 5.5 mm to 8 mm. These sizes roughly correspond to the Phillips head numbers. Pozidriv screws have a set of radial indentations (tick marks) set at 45° from the main cross recess on the head of the screw, which makes them visually distinct from Phillips screws.
This includes the original 6.35mm (quarter inch) jack and the more recent and standard 3.5mm (miniature or 1/8 inch) and 2.5mm (subminiature) jacks, both mono and stereo (balanced) versions. [2] XLR connectors, also known as Cannon plugs, used for analog or digital balanced audio with a balanced line. Digital audio interfaces and interconnects:
Ads
related to: 1/2 inch to mm socket