Search results
Results From The WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The Niro EV is equipped with a 64.8 kWh high-voltage battery, smart regenerative braking system 2.0, a heat pump, and a battery heating system. And it can run 463 km (WLTP combined) on a single charge. Also, the battery conditioning function is applied to automatically adjust the battery temperature according to the external environment.
An operating temperature is the allowable temperature range of the local ambient environment at which an electrical or mechanical device operates. The device will operate effectively within a specified temperature range which varies based on the device function and application context, and ranges from the minimum operating temperature to the maximum operating temperature (or peak operating ...
However, a similar tire inflated at an ambient temperature of 250 K (−23 °C; −10 °F) only needs to be warmed up by 2.5 K (2.5 °C; 4.5 °F) to see the same 1% increase in pressure. Due to the temperature-dependent pressure changes, seasonal temperature fluctuations can result in appreciable changes in tire pressure.
A cold start is an attempt to start a vehicle 's engine when ambient temperatures are much lower than its normal operating temperature. [1] A cold start can be difficult for an engine due to higher viscosity of oil and fuel in cold temperatures. Generally speaking, diesel engines have more difficulty starting at low outside temperatures than ...
Mass flow sensor. A mass (air) flow sensor (MAF) is a sensor used to determine the mass flow rate of air entering a fuel-injected internal combustion engine. The air mass information is necessary for the engine control unit (ECU) to balance and deliver the correct fuel mass to the engine. Air changes its density with temperature and pressure.
The venturi effect can reduce the air temperature by 39 K; 39 °C (70 °F). In other words, air at an outside temperature of 38 °C (100 °F), can drop to −1 °C (30 °F) in the carburetor. Carburetor icing most often occurs when the outside air temperature is below 21 °C (70 °F) and the relative humidity is above 80 percent. [1]
In heat transfer, thermal engineering, and thermodynamics, thermal conductance and thermal resistance are fundamental concepts that describe the ability of materials or systems to conduct heat and the opposition they offer to the heat current. The ability to manipulate these properties allows engineers to control temperature gradient, prevent ...