Net Deals Web Search

Search results

1. Results From The WOW.Com Content Network

2. Snellen chart - Wikipedia

   en.wikipedia.org/wiki/Snellen_chart

   Snellen chart. Purpose. Snellen chart is used to estimate visual acuity (last three rows are 20/15, 20/13 and 20/10) A Snellen chart is an eye chart that can be used to measure visual acuity. Snellen charts are named after the Dutch ophthalmologist Herman Snellen who developed the chart in 1862 as a measurement tool for the acuity formula ...

3. Visual acuity - Wikipedia

   en.wikipedia.org/wiki/Visual_acuity

   For 6/6 = 1.0 acuity, the size of a letter on the Snellen chart or Landolt C chart is a visual angle of 5 arc minutes (1 arc min = 1/60 of a degree), which is a 43 point font at 20 feet. [10] By the design of a typical optotype (like a Snellen E or a Landolt C), the critical gap that needs to be resolved is 1/5 this value, i.e., 1 arc min.

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

5. Fraction - Wikipedia

   en.wikipedia.org/wiki/Fraction

   A simple fraction (also known as a common fraction or vulgar fraction, where vulgar is Latin for "common") is a rational number written as a / b or ⁠ ⁠, where a and b are both integers. [ 9] As with other fractions, the denominator ( b) cannot be zero. Examples include ⁠ 1 2 ⁠, − ⁠ 8 5 ⁠, ⁠ −8 5 ⁠, and ⁠ 8 −5 ⁠.

6. Number Forms - Wikipedia

   en.wikipedia.org/wiki/Number_Forms

   Number Forms is a Unicode block containing Unicode compatibility characters that have specific meaning as numbers, but are constructed from other characters. They consist primarily of vulgar fractions and Roman numerals. In addition to the characters in the Number Forms block, three fractions (¼, ½, and ¾) were inherited from ISO-8859-1 ...

7. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.